What You Should Know About Sub-surface Surveying With Ground Penetrating Radar

You may reach us through our website;http://www.scanconcrete.com.au/

Additonal information can be found on this subject;

http://concretescanning.blogspot.com
http://concretescanningandinvestigation.tumblr.com/

Drilling through concrete – what to watch for

Products to Watch For When Drilling Through Concrete

When drilling holes in concrete, there is no substitute for quality devices and a sharp masonry drill bit that is also of high quality. If you have an inferior drill with little power, and a dull bit, your holes will certainly not be deep enough, and they will certainly be off-line.

If you utilize quality brand name drills such as DeWalt, Bosch, Black & Decker, or Makita, you will be on the right track. There is no substitute for quality and steady power when you are drilling concrete.

http://concretescanning.atlg.com.au

You need to always read the user’s manual of your drill extensively, and get to know your device. Understand and research where all the knobs and controls are located and exactly what they do. You need to know how to set your machine up and it needs to end up being force of habit. You have to be comfortable with how the drill deals with you hanging on to it.

Be sure and set the depth of your hole-to-be. While a few of the machines do have a depth control bar, if it does not discover how to set the depth with a pencil mark, or with masking tape.

Discover how to hold the drill properly while it is running. You will need to hold it like a weapon, with your forefinger in place on the trigger. Be sure to use it as intended if the drill has a manage for your other hand. If the drill does not have an additional handle, place your hand on the back of the housing on the drill while in operation.

Prior to you start to drill, make your mark on the wall with a soft pencil at the point where you are to make the hole. Mark the area with a dot or a little cross, but do not make the mark too large.

Position the suggestion of the bit on the mark and use adequate pressure to hold it in place, however do not press down too tough. You will get make use of to the quantity required by practice. Start out sluggish, and make a shallow hole that will assist the drill.

Now begin to drill in earnest, using a high speed. , if your drill has a hammer function utilize it periodically.. If you don’t have a hammer function, stop every ten seconds and pull back, and begin once more, letting the bit cool. Keep on the exact same tack till you reach the desired depth.

If the drill has a handle for your other hand, be sure to use it as meant. If the drill does not have an additional handle, position your hand on the back of the housing on the drill while in operation.

Now begin to drill in earnest, using a high speed. If your drill has a hammer function uses it occasionally.

C.S.I.Concrete Scanning & Investigation
54 Hooker Blvd
Broadbeach,
QLD
4218
Contact us: 0426 508 755